Measuring equipment

PERMO MEDO dosing unit

PERMO MEDO dosing units ensure the controlled introduction of formulated products into open or closed water systems. Your equipment’s efficiency is maintained and your systems are protected.

PERMO MEDO electromagnetic dosing pumps ensure precisesimple injection of formulated products. The microprocessor fitted to these pumps allows for numerous dosing combinations with or without interlocking with the flow rate of the system to be treated.

The suction rod fitted with a level detector stops the pump automatically when the reactant tank is empty. The defect is shown by a warning light on the control panel.

The unit comprises a dosing pump and a storage tank, with aspiration and injection accessories.

Dosing unit

PERMO MEDO 1

PERMO MEDO 3

PERMO MEDO 6

PERMO MEDO XG6

PERMO MEDO G

Maximum delivery back pressure (bars)

16

10

7

7

10

Rate of injection (per min)

180

Volume per shot (cm3/shot)

0,1

0,41

0,66

0,66

0,77

Max dose
litres/hr (bars)

1,4 (8)

5 (5)

8,4 (3,5)

8,4 (3,5)

6

 

Download spec sheet

PERMO METRIC 60 dosing unit

PERMO METRIC 60 dosing units are designed for the injection of PERMO conditioning products into open or closed water systems. These dosing units guarantee a high dosing rating and the homogenisation of treatment in your system.

All our dosing units are supplied with a graduated transparent polyethylene reactant tank, with drain plug and low level indicator.

They are used with a dosage proportional to the volume of water passed through an impulse counter (optional). A counter impulse multiplier / divider is fitted, guaranteeing accurate dosing and ease of use.

The unit comprises a dosing pump and a storage tank, with aspiration and injection accessories.

Dosing unit

PERMO METRIC 60

Maximum delivery back pressure (bars)

10

Rate of injection (per min)

180

Max dose
litres/hr (bars)

60 (10)

 

Download spec sheet

 

PERMO SAS entry-level dosing unit

PERMO SAS dosing units enable formulated products to be introduced into closed water systems to maintain their efficiency and protect them. Designed to be fitted to heating or chilled water systems, these introduction flasks are simple-to-uselow-cost solutions for the injection of PERMO formulated products.

PERMO SAS units should be fitted in parallel on the network’s feed water and back-up piping.

TYPE

PERMO SAS
15 l

PERMO SAS
40 l

Capacity (litres)

15

40

Connection diameter

DN 15

Funnel diameter (mm)

110

 

Download spec sheet

Do you want to get more information about our products?

Related Projects